User's Manual

5
6
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
Installing a Wilson Electronics In-Line
Signal Booster
Select a location to install the In-Line Signal Booster that is away from
excessive heat, direct sunlight, moisture and has proper ventilation. Do not
place the Signal Booster in an air-tight enclosure. Recommended installation
locations for In-Line Signal Booster are:
On a shelf •
In a closet •
Near a power outlet•
Near the Inside Antenna•
Where there is more than 5dB loss between•
In-Building Signal Booster and Inside Antenna
Note: It is important to have adequate air ventilation. Maintain at least 6
inches of clearance from surrounding objects.
The In-Line should be placed where it can make up for installation gain loss
due to cable, taps or splitters. Optimal location is near or directly connected to
the Inside Antenna.
Note: For distances of 20 feet or more, use Wilson low loss cable to prevent
significant signal loss or contact Wilson Electronics Technical
Support Team for assistance: 866-294-1660.
Note: Be careful when plugging the connector in so as not to damage
the center pins on the connectors.
IMPORTANT NOTICE
It is very important to power your Signal Booster using a •
surge protected AC Power Strip with at least a 1000 Joule
rating.
Failure to do this will void your warranty in the • event of a
power surge or lightning strike.