User's Manual

1
2
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
1. Install In-Building Signal Booster (such as the AG Pro 75 sold separately).
Use the installation guide for the model you purchased to install.
2. Select a location to install the In-Line Signal Booster that is away from
excessive heat, direct sunlight, moisture and has proper ventilation. Do not
place the Signal Booster in an air-tight enclosure.
3. The In-Line Signal Booster should be placed where it can make up for
installation gain loss due to cable, taps or splitters. Optimal location is near
or directly connected to the Inside Antenna.
4. a) Connect a cable to the in-building Signal Booster at the connector
labeled “Inside Antenna.”
b) Run the cable to the In-Line Signal Booster, attach to the connector
labeled “Outside Antenna.”
c) From the In-Line Signal Booster connector marked “Inside Antenna” run
a cable to the Inside Antenna. For more information on running cable (see
diagram on pages 3 & 4).
5. Before powering up the
In-Line Signal Booster, verify that all cables
are connected and check that all connections are tight. Note: Be careful
when plugging the connectors in so as not to bend the center pins on
the connectors ( see page 7).
6. The In-Line Signal Booster has been packaged with the gain control
knobs adjusted to the highest gain position. If one or both of the lights
are not green (see pages 9 & 10).
Quick Install Overview
See Installation Diagram on page 3. Contact Wilson Electronics Technical
Support Team with any questions at 866-294-1660.
Warning: Connecting the Signal Booster directly to a cell
phone with use of an adapter may damage the cell
phone and/or the Signal Booster.