User's Manual

9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
2. SOLID RED
If either of the two lights on the Signal Booster are solid red, this
indicates that the Signal Booster has shut down on that frequency
to prevent an oscillation (feedback). First, make sure that all the
connections are tight. Then reduce the gain of the Signal Booster
in small increments by rotating the gain control, counter clockwise,
waiting 5 seconds between each adjustment for the Signal Booster
to reset. Continue this adjustment until the light turns blinking or
solid green. When you are turning down the gain, you are reducing
the inside coverage area. If the amount of coverage area is
sufficient for your needs and the light is green the installation is
complete. If the coverage area is not large enough, it is necessary
to increase the separation distance of the antennas by moving them
horizontally or vertically farther apart, or both. Then increase the
gain until the red light comes on, and then slightly keep decreasing
the gain until the green or blinking green light appears. If after
separating the antennas your coverage area is still too small,
contact Wilson Electronics Technical Support Team for assistance:
866-294-1660.
If your installation takes longer than 15 minutes, it is possible to re-
enter the installation mode by disconnecting and reconnecting the
power supply from the Signal Booster.
3. SOLID GREEN
The indicator lights on the Signal Booster will be a solid green after
the first 15 minute installation period, if the unit is powered up and
working properly.