User's Manual

13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
14
4. If there is an “X” next to one of the gain values, this indicates that the
corresponding frequency has been shut off due to an oscillation.
b. A red light indicates that the frequency has been turned off due to an
oscillation.
Note: A orange light indicates that the receiver has been turned off.
This is to prevent disruption of cell towers.
R70A
OVERLOAD
62 AA’ 72
A75
A70X
A75
Band
Select
Reset
PUSH
PUSH
800
MHz
1700
/2100
MHz
UP
DOWN
PUSH
PUSH
1900
MHz
700
MHz
Band
Select
Reset
PUSH
PUSH
800
MHz
1700
/2100
MHz
UP
DOWN
PUSH
PUSH
1900
MHz
700
MHz
Wilson
®
Electronics, Inc.
Power
AG Pro Quint
Selectable
SMART
TECHNOLO GY
™
™
GAIN
GAIN
Figure 4
“X”= Oscillation
Warnings and Recommendations
Warning: The Outside Antenna must always be located so the back
or side points to the Inside Antenna. Never point the front
of the Outside Antenna toward the Inside Antenna – this is
to prevent oscillation.
Warning: Connecting the Signal Booster directly to the cell phone with
use of an adapter will damage the cell phone and/or Signal
Booster.
Warning: Use only the correct Wilson Electronics power supply. Use
of a non-Wilson Electronics product may damage your
equipment.
Warning: RF Safety: All inside antennas used with this Signal
Booster may not have gain (less cable loss) that exceeds
10.1 dBi and must be located at least 8 inches from all
people. Outside fixed antennas may not have gain that
exceeds 2.8 dBi (less cable loss) and must be located
least 27 inches from all people. The outside fixed antenna
must be connected with a minimum of 26’ of RG58 coaxial
cable. All antennas shown on page one meet these
requirements.
Warning: Verify that both the Outside Antenna and the Inside
Antenna are connected to the Signal Booster before
powering up the Signal Booster.