User's Manual

9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Mon.- Fri. Hours: 7 am to 6 pm MST.
During installation mode the Signal Booster is resetting itself very quickly
to aid the installer. The Signal Booster is equipped with one indicator light
for the 700 MHz band. For the first 15 minutes that the Signal Booster is
plugged in, it is programed for a test and alignment period.
1. BLINKING GREEN
If the Signal Booster 700 MHz light is blinking green, the Signal Booster
is operating properly. If you are happy with the coverage area in your
building, then you are done. Blinking will stop after the 15 minute
installation period.
2. BLINKING ORANGE
If the 700 MHz light on the Signal Booster is blinking orange, the Signal
Booster is experiencing receiver (cell tower) overload. The Signal
Booster has protection shut off circuits to prevent the disruption of cell
Understanding the Signal Booster Lights and
Troubleshooting
Note: If after the initial 15 minutes you are not done with the
installation, the Signal Booster can be reset and enter installation mode
again by disconnecting and reconnecting the power supply from the
Signal Booster.
For the first 15 minutes the
700 MHz light will do one of
the following 4 things:
Signal Booster
Signal Booster
Outdoor
Antenna
Outdoor
Antenna
Inside Panel
Antenna
Inside Panel
Antenna
Figure 1
Figure 2
CORRECT INSTALLATION INCORRECT INSTALLATION
Never point antennas toward each otherPoint antennas away from each other