User's Manual

13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
14
5 seconds between each adjustment for the Signal Booster to
reset. If you do not get a green light, turn the UL gain down 5 dB
and rotate the Outside Antenna. Continue to adjust the UL gain
and the Outside Antenna position until the light turns blinking
green. If the UL gain was reduced and the light is green and you
have good signal strength but are unable to place a call, it may
be necessary to lower the DL gain control to the same setting as
the UL. This is because some cell systems require a balanced
gain between UL and DL for proper operation. Contact Wilson
Electronics Technical Support Team for assistance:
866-294-1660.
3. SOLID RED
If the light on the Signal Booster is solid red, this indicates that
the Signal Booster has shut down to prevent an oscillation
(feedback). First, make sure that all the connections are tight.
Then reduce the DL and the UL gain of the Signal Booster in 5
dB increments by rotating the gain control counter-clockwise,
waiting 5 seconds between each adjustment for the Signal
Booster to reset. Continue this adjustment until the light
turns blinking or solid green. When you are turning down the
DL gain, you are reducing the inside coverage area. If the
amount of coverage area is sufficient for your needs and the
light is green, the installation is complete. If the coverage area
is not large enough, it is necessary to increase the separation
distance of the Inside and Outside Antennas by moving them
horizontally and/or vertically farther apart. Then increase
the DL and UL gains until the red light comes on, and then
decrease the gains until the green or blinking green light
appears. If after separating the antennas your coverage area
is still too small, contact Wilson Electronics Technical Support
Team for assistance: 866-294-1660.
4. SOLID GREEN
The 700 MHz indicator light on the Signal Booster will be a solid
green after the first 15 minute installation period, if the unit is
powered up and working properly.