User's Manual

7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
8
Cell Tower
Drip hole on bottom
Installing Lightning Protection
Outside Antenna Installation
The antenna should be mounted as shown in the illustration
above. The mounting bracket, included with antenna, is adjustable
and will accommodate pipe diameters from 1.25” to 2” (pipe sold
separately Part# 901117). Mount the antenna so that there is at
least 3 feet of clearance in all directions around it. Position the
antenna so that it has an unobstructed line of sight to the cell
tower’s strongest signal. Make sure the antenna is not pointing
across your own roof or at the inside antenna as this will cause the
oscillation protection circuitry to shut down the Signal Booster.
Warning: Lightning protection is recommended for all installations
(Part #859902 sold separately). Take extreme care to ensure that
neither you nor the antenna comes near any electric power lines.
Install the Lightning Surge
Protector (LSP) close to
the Signal Booster. Attach
the cable from the outside
antenna to the surge
protector, using a short
length of low loss cable;
attach one end to the LSP
and the other to the outside
antenna connector on the
Signal Booster. Attach a
ground wire to the LSP. LSP
sold separately, may be
purchased at www.WilsonElectronics.com or 866-294-1660.
To the outside antenna
Ground Wire
Lightning Surge
Protection
Signal Booster