User's Manual

13
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
14
antenna. Continue to adjust the uplink gain and the antenna
position until the light turns blinking green. Contact Wilson
Electronics Technical Support Team for assistance:
866-294-1660.
3. SOLID RED
If an indicator light on the Signal Booster is solid red, this
indicates that the Signal Booster has shut down to prevent
an oscillation (feedback). First, make sure that all the
connections are tight. Then reduce the gain of the booster,
downlink and uplink, in small increments by rotating the gain
controls, counter clockwise, waiting 5 seconds between each
adjustment for the booster to reset. Continue this adjustment
until the lights turn blinking or solid green. When you are
turning down the gain, you are reducing the inside coverage
area. If the amount of coverage area is sufficient for your
needs and the lights are green the installation is complete.
If the coverage area is not large enough, it is necessary to
increase the separation distance of the antennas by moving
them horizontally or vertically farther apart, or both. Then
increase the gain, downlink and uplink, until a red light comes
on, and then slightly keep decreasing the gain until a green
or blinking green light appears instead of the previous red
one(s). If after separating the antennas your coverage area is
still too small, contact Wilson Electronics Technical Support
Team for assistance: 866-294-1660.
If your installation takes longer than 15 minutes, it is possible
to re-enter the installation mode by disconnecting and
reconnecting the power supply from the Signal Booster.
4. SOLID GREEN
The indicator lights on the Signal Booster will be a solid green
after the first 15 minute installation period, if the unit is powered
up and working properly.