User's Manual

9
10
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: [e-mail]. Hours: 7 am to 6 pm MST.
Warning: The inside antenna must have a separation distance
from all persons that is at least 8 inches.
Note: Be careful when plugging the connector in so as not to
damage the center pins on the connectors.
Powering up a Wilson Electronics
Signal Booster
1. Never point the front of a directional outside antenna toward the
inside antenna. See Figures 1 & 2 on page 11.
2. Ensure that both the outside antenna cable and the inside
antenna cable are connected to the Signal Booster and the
connections are tight before powering up the Signal Booster.
3. Plug the 6-volt power supply into the Signal Booster input marked
“6V DC” (carefully, to avoid damaging the center pin) and then
into a wall outlet.
4. If the Signal Booster does not have two green lights, please see
pages 12-14.
5. Using multiple Signal Boosters in one installation could cause
interference to the cell tower.
6. Contact Wilson Electronics Technical Support Team with any
questions at 866-294-1660 or email [e-mail].
Technical Support hours are 7 am to 6 pm MST.
Note: For distances of 20 feet or more, use Wilson low loss cable to
prevent significant signal loss.