User's Manual

4
Installing a Wilson Amplifi er
Select a location to install the amplifi er that is away from excessive heat, direct
sunlight, moisture and that has proper ventilation. Do not place the amplifi er in
an air-tight enclosure.
Recommended installation locations for in-building amplifi ers are:
• On a wall
• On a desk
• Near a power outlet
Run the outside antenna cable to the amplifi er and attach it to the connector
labeled “outside antenna” on the amplifi er. Run the inside antenna cable to the
amplifi er and attach it to the connector labeled “inside antenna” on the amplifi er.
Note: Be careful when plugging the connector in so as not to damage the center
pins on the connectors.
Connect the outside antenna to the amplifi er with low loss coax cable (available
from Wilson Electronics). Place the inside antenna in the center of the area
needing the amplifi ed signal. It is important to have at least 70 feet of separation
between the antenna and amplifi er.
AC/DC
Power Supply
Amplifier
Supports
Multiple
Users
Outside Antenna
Omni-Directional
Antenna Shown
Inside Antenna
Antenna Separation
70 feet minimum separation
between antennas
Inside Antenna
Mounting Bracket
Warning: See RF
safety warning on page 6.
Warning: Connecting the
amplifi er directly to the cell phone
with use of an adapter will damage
the cell phone.