Specifications

77
The universal connector must be placed
directly on the cell phone or cellular data
card to work properly. Attach the universal
connector to the cell phone or cellular data
card with the VELCRO
®
included in the
package. IMPORTANT: The adhesive of the
gray Velcro patch that adheres to the back
of your phone needs time to “cure.” For best
results, do not use the Velcro connection for
a minimum of 24 hours after application.
The universal connector included in the
package is long enough to reach the
amplifi er location. This allows for ease and
convenience of use.
To adjust the universal connector for the
best signal, go to a weak signal location
where your cell phone registers only 1-2 bars
without the universal connector connected.
Then, attach the universal connector to
the phone and you should see a signal
improvement of 2 or more bars.
NOTE: Many phones take up to 20 seconds
to reset the bar indicator.
To maximize performance, attach the
universal connector as close as possible to the original antenna on your cell phone or cellular
data card.
For cell phones with an internal antenna,
place the universal connector on the back,
upper left-hand corner of the phone. (Figure
1) NOTE: Certain phones, such as the
Motorola RAZR, have internal antennas at
the base, rather than the top, in which case
the universal connector should be attached
at the bottom rear of the phone.
For cell phones with an external antenna,
place the universal connector directly below
the phone’s original antenna. (Figure 2)
If you have any questions as to the location
of the antenna on your phone, call Wilson
Technical Support at 866-294-1660 or visit
www.wilsonelectronics.com.
Amplifi er Universal
Connector
Figure 1
Figure 2
To Amplifi er
Installing a Wilson Universal Connector
Option B (Attached)
Cellular data card