User's Manual

2
Installation Instructions for the Following Wilson Amplier:
SignalBoost Vehicle Wireless Dual-Band Amplier
Part # 801230 Model #271230
FCC ID: PWO271230SA (pending) IC:4726A-271230SA (pending)
The term “IC” before the radio certication number only signies that Industry Canada
technical specications were met.
Inside this Package
How it Works
Your new Wilson amplier has been carefully engineered to signicantly improve the
performance of your cell phone or cellular data card in mobile applications. Together with an
outside antenna, the amplier’s state-of-the-art technology is designed to increase your signal
up to 10 times, reduce disconnects and dropouts, and increase data communication rates
needed for 3G technologies.
The outside antenna will collect the cell tower signal and send it through the cable to the
amplier. The signal is then boosted and sent through the Ultra-slim inside antenna. Your
cell phone or data card then communicates with the improved signal. When the cell phone
or data card transmits, the signal goes through the inside antenna, is boosted by the
amplier and broadcast back to the cell tower through the outside antenna. The Ultra-slim
antenna may also be attached directly to a laptop or cellular data card for maximum signal
performance.
Wilson Electronics manufactures a wide variety of antennas to help you customize your
amplier for your specic application. Several are shown below. See your dealer or visit
www.wilsonelectronics.com.
Wireless
amplier
NMO
Mount
Dual-BandMagnet
Mount
Dual-Band
Trucker
Mount
Dual-Band
Mini
Magnet
Dual-Band Marine
Antenna
Dual-Band
NOTE: Use of this amplier with an
antenna gain higher than 6.12 dBi is in
violation of FCC regulations for which the
offender is fully liable. All Wilson mobile
antennas are 6.12 dBi or less.
Ultra-slim
antenna
DC plug-in
power supply