User Guide

English
44 WILO SE 06/2011
9 Commissioning
Safety
Preparation Before commissioning, the pump and module must be at ambient
temperature.
9.1 Filling and bleeding • Prime and bleed the system as required.
ON
Confirming will reset the set-
tings to factory settings.
Caution!
All manual settings will be lost.
Is not displayed when
“access disable” is active.
Is not displayed when build-
ing management system
active.
6.0.0.0
Error acknowledg-
ment
For additional information, see
chapter 11.3 “Acknowledging
errors” on page 59.
Only displayed if an error is
present
7.0.0.0
Access disable “Access disable” inactive
(changes possible)
(for further information, see
chapter 8.6.7 “Activating/deacti-
vating access disable” on
page 37).
“Access disable” active (no
changes possible)
(for further information, see chap-
ter 8.6.7 “Activating/deactivating
access disable” on page 37).
No. Designation Type Symbol Values/explanations Display conditions
±
±
DANGER! Danger of death!
Failure to install safety devices of the electronic module and the
motor can cause electrical shock or contact with rotating parts,
potentially resulting in life-threatening injuries.
• Before commissioning as well as after maintenance work, all
safety devices such as module covers and fan cover that were
removed must be reinstalled.
• Keep a safe distance during commissioning!
• Never connect the pump without the module.
CAUTION! Damage to the pump!
Dry running will destroy the mechanical seal.
• Make sure that the pump does not run dry.