User Guide

English
34 WILO SE 06/2011
Access disable menu The main menu <7.0.0.0> is only displayed when DIP switch 2 is in the
ON position. It cannot be reached via normal navigation.
In the “Access disable” menu, the access disable can be activated or
deactivated by turning the red button. The change is confirmed by
pressing the red button.
8.6 Operating instructions
8.6.1 Adjusting the setpoint
On the status page of the display, the setpoint can be adjusted as fol-
lows (Fig. 33):
• Turn the red button.
The display changes to menu number <1.0.0.0>. The setpoint begins
to flash and is increased or decreased by continuing to turn.
• To confirm the change, press the red button.
The new setpoint will be accepted and the display will return to the
status page.
8.6.2 Changing to menu mode To change to menu mode, proceed as follows:
• While the display is showing the status page, press the red button for
two seconds (except in case of an error).
Standard behavior:
The display changes to menu mode. Menu number <2.0.0.0> is dis-
played (Fig. 34).
Service mode:
If service mode is activated via DIP switch 1 menu number <5.0.0.0>
is displayed first. (Fig. 35).
Error case:
In case of error, menu number <6.0.0.0> is displayed (Fig. 36).
Fig. 33: Entering the setpoint
12.3
1.0.0.0
RPM
RPM
2200
1800
1.0.0.0
2s
Fig. 34: Standard menu mode
2.0.0.0
±
2s
ON
1
12.3
Fig. 35: Service menu mode
5.0.0.0
±
2s
ON
1
12.3
Fig. 36: Error case menu mode
6.0.0.0
±
E000