User Guide

English
Installation and operating instructions Wilo-Stratos GIGA 43
5.5.1.0 P parameter Setting of the proportional term
of the control
5.5.2.0 I parameter Setting of the integral term of
the control
5.5.3.0 D parameter Setting of the derivative term of
the control
5.6.0.0 Error Settings for behavior in case of
error
5.6.1.0 HV/AC HV “heating” mode
AC “cooling/air-conditioning”
mode
5.6.2.0 Emergency opera-
tion speed
Display of emergency operation
speed
5.6.3.0 Auto reset time Time until automatic acknowl-
edgment of an error
5.7.0.0 Other settings
5.7.1.0 Display orientation Display orientation
Display orientation
5.7.2.0 Pressure value cor-
rection
When pressure value correction
is enabled, the differential pres-
sure deviation measured by the
differential pressure sensor that
is factory-fitted on the pump
flange is taken into account and
corrected.
Only displayed in Δp-c mode.
Is not displayed for all pump
variants.
Pressure value correction off
Pressure value correction on
5.7.6.0 SBM function Setting for behavior of signals
SBM run signal
SBM readiness signal
SBM mains on signal
5.7.7.0 Factory setting OFF (default setting)
Settings are not changed by
confirming.
Is not displayed when
“access disable” is active.
Is not displayed when build-
ing management system
active.
No. Designation Type Symbol Values/explanations Display conditions
±
±
±
±
±
±
±
±
±