Installation Instructions

CHAIN

FIXTURE LOOP

FIXTURE

ELECTRICAL BOX

MOUNTING BAR

MOUNTING PLATE SCREW

CANOPY

SCREW COLLAR

THREADED NIPPLE

FOR SEMI FLUSH MOUNT ONLY-:Unscrew and remove the fixture loop from the fixture, then remove the cap nut screws and

washers by unscrewing the cap nuts.

FOR SEMI FLUSH MOUNT ONLY-:Install the mounting plate with the two mounting studs to the electrical box with two

mounting plate screws. 9SKIP TO STEP

If necessary, screw the shorter end of the threaded nipple tightly onto the mounting bar.

Temporarily unscrew and remove the collar nut from the screw collar, then screw the screw collar tightly onto the threaded

nipple.

Secure the mounting bar to the electrical box with two mounting plate screws.

Screw the fixture loop onto the fixture. Determine the wanted height of the fixture and remove a portion of the chain by

opening a link and removing it from the bottom.

Install the canopy and collar nut onto the chain (in that order), then install the open link onto the fixture loop and secure it

in place by closing the link.

Weave the cord through the chain and canopy, then trim the cord leaving enough to make electrical connections.

Connect the fixture to a suitable ground in accordance to local electrical codes.

Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.

Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.

FOR SEMI FLUSH MOUNT ONLY-:Align, then place the fixture onto the mounting plate studs and secure it with the two cap

nuts. SKIP TO STEP 14

Neatly place all the wires into the electrical box, place the canopy onto the ceiling, and secure it in place by screwing the

collar nut tightly onto the screw collar.

Screw the lamps into the sockets.

COLLAR NUT

Install the Fixture

LAMP

FIXTURE

CAP NUT

FIXTURE

LOOP

MOUNTING

PLATE

MOUNTING PLATE STUD

CAP NUT

SCREW

Semi-Flush Mounting

WASHER

12 12