Installation & Assembly
III
V
VI
VIII
IMPORTANT SAFETY INSTRUCTIONS:
- Please read instructions in their entirety prior to assembly and installation.
- We strongly recommend installation by a licensed Electrician.
- Make sure the electricity to the wires you are working with is shut off; the
fuse is removed or circuit breaker is turned off. Simply turning the power off
using a light switch is not sufficient to prevent electrical shock!
- All electrical connections must be in accordance with local and National
Electrical Code (NEC) standards.
TOOLs REQUIRED:
Slotted screwdriver, Adjustable wrench, Step ladder, Wire cutters, Wiring
supplies as required by electrical code.
ASSEMBLY AND INSTALLATION:
1. Shut off main electrical supply at fuse box or circuit breaker
2. Thread ficxture cord and wiring (VIII) through canopy (VI) and fixture
extension (V). Screw fixture extension into fixture.
3. Affix mounting plate (II) to wall junction box using mounting plate screws
(III).
4. Thread wall box wires through mounting plate (II)
5. Wrap ground wire under and around ground screw (IV) marked GND.
Fasten Ground screw to make sure ground wire is securely connected.
6. Connect black fixture wire to black supply wire and white supply wire to
white supply wire using wire connectors (provided). Wrap connection with
electrical tape.
7. Connect fixture ground wire and house ground wire
8. Carefully place wiring back in junction box.
9. Place canopy (VI) over mounting screws and mounting plates (II), and affix
to wall using mounting screws (I) and decorative fastener (VIII).
10. Thread light canopy ring (IX) over fixture (VIII), then thread light conpy (x)
over fixture. Tightnen using fastener ring (XI)
Items included:
III
IX
IV
J-BOX
X
VII
XI
(1) light canopy
(1) fastener ring
(1) light canopy ring
(1) light bulb
(1) mounting plate
(1) fixture
(1) canopy
(2) mounting plate screws
(2) conopy screws
(4) nuts
(4) washers