Installation & Assembly

4. Connect the ground wires (bare
copper or green) from your fixture to
the ground wire (bare copper or
green) or ground screw in the
electrical box. Connect the black wire
(or wire marked “SPT-1”) from the
fixture to the black wire in the
electrical box and connect the white
wire (or the wire with ribbed side) from
the fixture to the white wire in the
electrical box.
5. Once connections of wires are
completed, carefully tuck wires and
wire nuts into the outlet box making
sure no bare wire (on the black and
white) is visible at the wire nuts. Slide
canopy into position and tighten in
place by nut into position.
6. Hook the support arms onto
fixture and then into the hoop.
7. Install specified bulb type and
wattage (not included).
CHANDELIER
Power
Cord
Chain
Connector
Lower
Canopy
Nipple
Upper
Connector
Nut
1 . Loosen the upper
connector from nipple. Attach the
nipple to the mounting bracket
and adjust until it will clear the
canopy when assembled (Place
the canopy over the nipple and
tighten the upper connector onto
the nipple until snug. The upper
connector should hold the canopy
snug to the ceiling). Lock the
nipple in the correct position
using the star washer and hex
nuts. Attach the mounting bracket
to the electrical box using
electrical box screws (not
included) .
2. To attach chain loop to light
fixture, use a screwdriver and
wrench to open and close chain
loop. Ensure to close the
opening. Weave the power cord
and ground wire through the links
in the chain.
3. Loosen the nut on the upper
connector and slide it down the
chain towards the lower
connector. Slide the canopy down
the chain towards the lower
connector. Feed the wire
through nut, canopy, the upper
connector and onto the nipple.
Tighten the upper connector onto
the nipple. Spread the other end
of the chain open and fasten to
the upper connector. Ensure the
opening is closed.
Canopy
Nut
White
Black
House supply
Ground wire
Fixture
Ground
wire
INSTALLATION:
Upper
Connector
Nipple
Bulb
Support
Arm
Hoop
SAFETY PRECAUTIONS:
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Wiring supplies
as required by
local electrical
code
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND
WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL BOX.
4. TO CLEAN THE FIXTURE, TURN OFF THE POWER, WAIT FOR IT TO COOL, AND WIPE THE FIXTURE WITH A
CLEAN, SOFT CLOTH.
NOTE: Product may not look exactly as shown in figures.
Nipple
Hex Nut
Electrical Box
Electrical
Box Screws
(not included)
Mounting
Bracket
Star
Washer