Installation & Assembly

INSTALLATION:
SAFETY PRECAUTIONS:
!
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS
READ ALL INSTRUCTIONS
IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1. Loosen “B”. Adjust stud to
desired length and lock in place
with “B”.
2. Mount the mounting bracket
to outlet box using outlet box
screws (not included). Make sure
the studs on the mounting
bracket are facing out from the
outlet box.
3. Firmly attach the fixture
ground wire (bare copper) to the
mounting bracket with the
ground screw (by wrapping
around the ground screw) and
then connect it to the house
supply ground wire with a wire
nut. Connect black wire from
fixture to black wire in outlet box
and connect the white wire from
fixture to white wire in outlet
box.
4. Once connections of wires
are completed, carefully tuck
wires and wire nuts into the
outlet box making sure no bare
wire (on the black and white) is
visible at the wire nuts.
5. Position fixture over studs
on mounting bracket assembly.
Secure fixture in place with star
washers and cap nuts.
6. Remove spinner nut from
socket. Position cover and glass
on lamp and secure with spinner
nut.
7. Install specified bulb type
and wattage.
8. After Installation, seal
around the top and side
perimeter between the fixture
and the wall surface with
weather resistant caulking. The
bottom should be left
un-caulked to prevent moisture
build-up. Apply a small amount
of weather resistant caulking
around the side perimeter
between the cap nut and
mounting plate.
1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.
2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE
BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
3. FIRMLY ATTACH THE FIXTURE GROUND WIRE (BARE COPPER) TO THE MOUNTING BRACKET WITH THE
GROUND SCREW (BY WRAPPING AROUND THE GROUND SCREW) AND THEN CONNECT IT TO THE
HOUSE SUPPLY GROUND WIRE WITH A WIRE NUT.
NOTE: Product May Not Look Exactly As Shown In Figures.
Studs
Stud
“B”
Cap
Nut
Star
Washer
Bulb
TOOLS AND MATERIALS REQUIRED:
Phillips
Screwdriver
Wire Cutters
Pliers Wrench
Wiring supplies
as required by
the Canadian
Electrical Code
and/or the
Quebec
Electrical code
OUTDOOR
LIGHTING
Cover
Glass
Spinner
Nut
Weather
Resistant
Caulking
(not included)
Outlet
Box
Outlet Box Screws
(not included)
Mounting
Bracket
House Supply
Ground Wire
Fixture
Ground Wire
Ground
Screw
Black Wire
White Wire