Installation & Assembly

SAFETY PRECAUTIONS:

1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE.

2. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE

BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE

HAZARDS INVOLVED.

CONNECT THE GROUND WIRES (BARE COPPER OR GREEN) FROM YOUR FIXTURE TO THE GROUND

WIRE (BARE COPPER OR GREEN) OR GROUND SCREW IN THE ELECTRICAL OUTLET BOX.

INSTALLATION:

INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS

READ ALL INSTRUCTIONS

IMPORTANT SAFETY

INSTRUCTIONS

SAVE THESE INSTRUCTIONS

TOOLS AND MATERIALS REQUIRED:

Wire Cutters

Pliers

Wrench

Wiring supplies

as required by

the Canadian

Electrical Code

and/or the

Quebec

Electrical code

Phillips

Screwdriver

CHANDELIER

NOTE: Product may not look exactly as shown in figures.

Step 1

Step 2

Long glass

Stud

Hole

Short glass

Knob

Insert short glass as shown.

Adjust downside of glass to be inserted behind 2 knobs.

Put the fixture in position as in figure 1.

Insert long glass as shown.

Adjust downside of glass to be inserted behind 2 knobs and

push glass in place.

Put one stud on the frame to hold the glass in place temporarily.

PAGE 1
CHANDELIER INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO PERSONS READ ALL INSTRUCTIONS ! IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS TOOLS AND MATERIALS REQUIRED: Phillips Screwdriver Wire Cutters Pliers Wrench Wiring supplies as required by the Canadian Electrical Code and/or the Quebec Electrical code SAFETY PRECAUTIONS: 1. TURN OFF ELECTRICAL POWER BEFORE STARTING INSTALLATION OF LIGHT FIXTURE. 2.
PAGE 2
Step 3 Tighten the screw with the rubber cube to hold the glass in place as shown. Screw Repeat steps for the other long glass and short glass. Rubber cube Step 4 Insert the 4 plastic bushings as shown. Plastic bushing Knob Step 5 Remove the 2 studs on the frame in step 1. Remove the 4 screws on the fixture, then insert the fixture into the frame as shown. Fixture Tighten the 4 screws to hold the fixture in place.
PAGE 3
Step 6 Step 7 Attach mounting bracket to electrical outlet box with electrical box screws (not included). Hex Nut Ground Wire Star Washer Electrical Outlet Box Install the length of rod that is required by threading wire through the rod and securing it to the fixture. Mounting Bracket Tighten the hex nut and washer to the stem on the canopy.