ASSEMBLY INSTRUCTIONS Counter Height set ASSEMBLY 60 Minutes 2-Person REQUIREMENTS Assembly Time Assembly Per Stool {Approximate) Thank you for purchasing our product! Please refer and use this assembly instruction to assemble the product. Contact our customer service department in case there are any missing or damage parts or hardware. Replacement parts are normally shipped within 2 or 3 days. We appreciate your business! ASSEMBLY PREPARATION 1.
ASSEMBLY INSTRUCTIONS Counter Height set Parts and Hardware List A FRAME specs 1 Po B Q LOWER STRETCHER |2PCS| J @ Loop PCS stool Frame | PCS D | WOODWARD we | b STOOL LEG PCs LEFT LEG E frowardness) epochs M @W‘“ BOLT PCS RIGHT REAR LEG 1Pc | N @m SCREW PCS G RIGHT FRONT T O ~. ALLEN WRENCH | 1pg FRONT STRETCHER |1pg POST a) Place Bottom Board (C} and Bar Top (D) bottom-side up. b} Position each Frame (A} to align to {(C) and (D) ¢} Use Screws (N) to fasten (A} to (C) and (D).
ASSEMBLY INSTRUCTIONS Counter Height set STEP 4 a) Install the first Lower Stretcher (B} as shown. a) Install the the second Lower Stretcher (B) b) Use Bolt (M) to fasten (B) to Right Legs and following the same procedures in Step 3, Stretcher Posts and tighten with Allen Key (O), ¢} Do not tighten (M) completely until all of (M) are in place.
ASSEMBLY INSTRUCTIONS Counter Height set STEPPER STEP 8 a) Place Stool Top (J) bottom-side up as a) Position Stool Frame (K} to Legs (L) as shown. shown. 1) Position Stool Legs (L) to (J) and use b) Align the drilled holes on (K) and (L) Bolt (M) to fasten. and use Bolt (M) to fasten, ¢) Do not tighten (M ) completely until all o) Do not tighten (M ) completely until all of of (M) are in place. (M) are in place. STEP 9 Position the completed bar stool upright. Check and tighten all of Bolts (M).
