Assembly Instruction

ManualsBrandsWilliston Forge ManualsCeiling LightsKarole 1-Light Single Globe Pendant

1. Attach the nipple to the mounting strap, then secure it with a

washer and a hex nut.

2. Attach the mounting strap to the outlet box by using two

mounting screws.

3. Secure the top loop to the nipple.

4. Choose the length of the chain you need, then weave the

fixture wire and the fixture grounding wire through the chain,

collar and canopy.

5. Connect one end of the chain with the loop by using a loop

lock.

6. Connect the other end of the chain with the top loop by using

another loop lock.

7. Thread the fixture wire and fixture grounding wire through

the top loop, nipple and mounting strap.

8. Pull out the outlet wires and house grounding wire from the

outlet box. Make wire connections using the wire nuts:

---The smooth wire (marked) from the fixture to the black

wire from the power source.

---The ridged wire (unmarked) from the fixture to the white

wire from the power source.

---Attach the fixture grounding wire to the mounting strap

with the green grounding screw. Then connect it to the

house grounding wire with a wire nut.

Carefully put the wires back into the outlet box.

9. Attach the canopy to the mounting strap by inserting the top

loop, then secure it with the collar.

CAUTION: With silicone caulking compound, caulk

completely around where back of canopy meets with the

ceiling surface to prevent water from seeping into the outlet box.

10. Attach the glass shade and frame onto the fixture, secure it with the rubber pads and ball nuts.

11. Install a bulb (not included). See relamping label at socket area or packaging for maximum allowed

wattage.

12. Turn on the power at the main fuse or circuit breaker box.

Loop

Contents of Spare Parts:

Assembly Kit

(1 SET)

(4461MM)

Outlet Box

House Grounding Wire

Wire Nut

Fixture Wire

Fixture Grounding Wire

Mounting Strap

Green Grounding Screw

Mounting Screw

Nipple

Canopy

Top Loop

Hex Nut

Washer

Collar

Loop Lock

Chain

Fixture

Bulb Type G Max.60W

(not included)

Ball Nut

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Glass Shade

(1 PC)

(9315S)

Ball Nut

(2 PCS)

(4460BB)

Rubber Pad

Glass Shade

Frame