Assembly Instruction

Carefully unpack all lamp parts from the carton.
1.Take the lamp carefully out of the Carton,and place it on a flat surface.
2. Be sure the power to the installation point is power off
3.Place the universal bar over the ceiling canopy and thread mounting ball onto
the mounting screw to secure it .Hand tighten until snug.
4.Determine the number of rods to be assembled to the fixture body according
to your hanging height. Pass supply wires through the rods. Thread the rods to
connect nipple #1 and nipple #2. Hand tighten until snug.
5.Pass the supply wires through the ceiling canopy and the hole in the middle of the universal bar.
6.Install correct bulb to the socket referring to fixture markings and/or labels for maximum wattage. (Included)
ASSEMBLY INSTRUCTIONS