Installation & Assembly

INSTALLATION MANUAL

WARNING:

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODES BY A

PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS

INVOLVED.

* Check for electric, gas, & plumbing lines before drilling or consult a professional.

* Turn off your electricity at the circuit breaker or main fuse box before installation.

* Do not restore power to the line until fully installed.

* Do not exceed the recommended wattage.

* Always allow bulbs to cool for 10 minutes before changing.

SEMI-FLUSH MOUNT

This fixture has been rated for up to three (3) E26 Socket

60-Watt maximum candelabra light bulbs or LED equivalent

bulbs (not included).

To avoid the risk of fire, DO NOT EXCEED THE

RECOMMENDED LAMP WATTAGE.

The lighting fixture is meant for indoor use.

Pls read the installation instructions carefully and follow the

steps:

1. Remove the mounting bracket (A) from the canopy (C).

Attach mounting bracket (A) to junction box with screws

(B). Junction box is not included.

2. Pass the wires through the tube (F) and canopy (C). Then

tighten the lamp body (G), tube (F) and canopy (C).

3. Make electrical connections using wire nuts (D).

4. Attach the canopy (C) to the mounting bracket (A) and

screw it by canopy nuts (E).

5. Install the light bulb (not included)

PAGE 1
SEMI-FLUSH MOUNT INSTALLATION MANUAL WARNING: THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. * Check for electric, gas, & plumbing lines before drilling or consult a professional. * Turn off your electricity at the circuit breaker or main fuse box before installation. * Do not restore power to the line until fully installed. * Do not exceed the recommended wattage.