Owner Manual - Bar stool

Step 3
Step 4
4.1. Repeat step 2.2 and step 3 for 3 other legs (C).
4.2. Turn the Barstool back to normal flat ground
EXERT pressure, floorwards, onto the barstool
This pressure will help the Legs and Seat panel reach alignment at all joints.
Check for wobbles.
In a sequential manner, gradually tighten all Bolts and screws until evenly secured.
Inspect the barstool and make sure all parts are adequately connected.
Your barstool is ready for use.
This barstool can only be used on a flat, level surface.


B
Round iron frame
Step 4.1
Step 4.2
B
C
C
Page 5 of 6
Insert Foot support frame (B) into the leg (C), using screw (k) as above
picture.Affix Foot support frame (B) and leg (C) by using Allen key (
④ ).
Do not fully tighten the Bolts.