Owner Manual - Bar stool

ManualsBrandsWilliston Forge ManualsBar FurnitureTwickenham Bar with Wine Storage

Table Of Contents



Caution : You must read this before you proceed

Please look in the seat panel for hardware packs.

BARSTOOL

CAUTION : This Barstool is NOT a TOY.

Keep your child / children at bay during the assembly process.

For moving the Barstool and to prevent damage to the Barstool two

adults are needed to execute this action.

Page 1 of 6

Summary of content (6 pages)

PAGE 1
Assembly Instructions Caution : You must read this before you proceed Please look in the seat panel for hardware packs. BARSTOOL CAUTION : This Barstool is NOT a TOY. Keep your child / children at bay during the assembly process. For moving the Barstool and to prevent damage to the Barstool two adults are needed to execute this action.
PAGE 2
Label Picture A Seat panel B Foot support frame C Label Description Leg Picture QTY 1 1 4 Description QTY ① Bolt (M6x45mm) 5 ② Screw(M6x40mm) 5 ③ Flat Washer (M6.
PAGE 3
Before Beginning Assembly: OVERVIEW Seat panel(A) Leg (C) Leg (C) Foot support frame (B) FRONT FACING This Barstool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the barstool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
PAGE 4
Step 1 Unpack and place all parts on a clean, non-marring surface. Step 2 Step 2.1 C A Step 2.2 A    2.1. Turn the Seat panel (A) facedown onto a clean, flat surface to avoid any scratches or damage to the product. 2.2. Insert leg (C) into the seat panel (A), put the flat washer (③) and bolt (①) as above picture. Affix leg (C) and seat panel (A) by using Allen key (④). Do not fully tighten the Bolts.
PAGE 5
Step 3 Round iron frame C B   Insert Foot support frame (B) into the leg (C), using screw (k) as above picture.Affix Foot support frame (B) and leg (C) by using Allen key (④). Do not fully tighten the Bolts. Step 4 C B Step 4.1 Step 4.2 4.1. Repeat step 2.2 and step 3 for 3 other legs (C). 4.2. Turn the Barstool back to normal flat ground EXERT pressure, floorwards, onto the barstool This pressure will help the Legs and Seat panel reach alignment at all joints. Check for wobbles.
PAGE 6
Page 6 of 6