Owner Manual

8
1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL LINING AT LEAST ONE SIDE UP WITH A STUD.
2. LIGHTLY MARK YOUR WALL USING A PENCIL IN EACH MOUNTING HOLE ON THE FLANGES.
3. REMOVE UNIT FROM WALL AND PREDRILL YOUR MARKED SPOTS USING A
3
16
" DRILL BIT.
IF NOT GOING DIRECTLY INTO STUD, USE ANCHOR (ITEM 7). DRILL
5
16
" HOLE AND HAMMER
ANCHOR INTO PLACE.
4. REMOVE WALL FLANGE FROM UNIT BY LOOSENING SET SCREW ON PIPE AND MOUNT IT TO WALL
USING SCREWS (PART 4).
5. REFER BACK TO STEP 1 TO REMOUNT REST OF UNIT BACK TO FLANGE. ENSURE SHELF SURFACE IS
LEVEL; TIGHTEN SET SCREW PERMENANTLY THIS TIME.
3
TIGHTEN
SET SCREW
PERMENANTLEY
6