Installation & Assembly

Using Long Bolts ( ) with Small Flat Washers( ), as shown in the picture (1) and Middle
Bolts ( ) & Small Flat Washers( ) with Sleeve Nuts( ), as shown in the picture (2). Tighten
with using the Allen Key ( ). This sequential manner will reduce possible distortion of frame.
CAUTION!! DO NOT OVER TIGHTEN.
OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
SLOWLY TIGHTEN ONLY UNTIL SECURE AND STABLE.
You are now at the FINAL stage of this assembly.
In a sequential manner, drive in and fully tighten all bolts.
Thereafter, turn the table right way up.
The Table now is ready to be used.
Caution: This Table can only used on a flat, level surface.
5 OF 6
4
3