Installation & Assembly

Place the Table (A) with the fabric face skywards onto a clean, soft surface to avoid any
scratches or damages to the product.
Lift legs upright in degrees until the braces are locked, as shown in the diagram.
Attach the Leg Connector (B) to the Table(A).
You may need to apply a little pressure to the Legs-pushing outwards, so as to enable
the leg Connector (B) to be slotled into position.
Using the Short Bolts(1) with Big Flat Washers(2), tighten the bolts by using the Allen
Key(7),as shown in the diagram.
WARNING!! DO NOT OVER TIGHTEN.
OVER TIGHTENING COULD LEAD TO DAMAGE OF THE PRODUCT.
SLOWLY TIGHTEN UNTIL SECURE AND STABLE.
4 OF 6
1
2
7