Installation & Assembly

STEP 2: Gently put the metal frame (B) on the floor and make sure the backside is upwards.

Attach the metal leg to the metal frame (B) and screw in 8 screws ( I ). Finally tighten all

screws with Allen wrench tool (k).

4/6

STEP 3: Gently put the panel (A) on the floor and make sure the backside is upwards. Attach the

metal leg to the panel (A) and screw in 4 screws (J). And then tighten all screws (J) with Philips

screw driver. Then set the table upright and ensure all screws have been tightened before use.