Installation Guide

STEP 3 - Attach the Lanyard
A. The purpose of the lanyard is to provide a means to support the
fixture hands free from the junction box while connecting the
electrical wires.
B. Turn the Button Stop so it may be inserted into a Crossbar slot. Make
sure the Button Stop is completely inside the Crossbar. Slowly
release the fixture to make sure it is supported by the Button Stop.
Proceed to the wiring steps in the next step. Once you are complete
with the wiring, the Lanyard will push into the junction box when the
fixture is placed for final mounting.
Button Stop
Lanyard
Slot
Slot
Crossbar
Figure 3
STEP 5 Install Ceiling
Canopy to Crossbar
-
A. Attach the Ceiling Canopy
(DD) over the end of the
Nipple and secure with the
Hex Nut. Hand tighten until
snug.
B. Thread the Ball onto
the Nipple and hand tighten
until snug.
Lock
DD
Figure 5
Figure 4
STEP 4 - Making the Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into outlet box.
Note: If the electrical wire is going to be cut shorter than provided
you will need to identify the "L" line wire and the "N" neutral wire
before you cut the excess wire off. One is labeled N and the other
labeled L. To do this separate the "L" line wire and the "N" neutral
wire as far as you need to. Re-label the wire near where you want to
make the cut. Be sure to mark the wire on the side of the fixture and
not on the excess wire being cut and removed.
B.
Green Ground Screw
on the Crossbar
White wire
from outlet box
Supply
identified with the Label “N”
wire from fixture
Black wire from
outlet box (or Red)
Supply
identified with the label “L”
wire from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
Nipple
Hex Nut
Lock Ball
Crossbar
Figure 6
STEP 6 - Install the Bulb
A. Insert the bulb onto the socket and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
FINISH: RUSTIC BLACK
Vintage Bulb
(recommended
but not supplied)
10.25 x 4.75””
38.5”
51”
8.25"
15”
2of2