Owner Manual

8
3
4
FROM STEP 2
1. PLACE THE UNIT IN DESIRED LOCATION AGAINST WALL WHILE LINING EITHER THE RIGHT OR LEFT
FLANGE WITH A WALL STUD.
2. LIGHTLY MARK YOUR WALL USING A PENCIL THROUGH THE FLANGE HOLES.
(4 MARKS NEEDED TOTAL).
3. REMOVE UNIT FROM WALL AND PREDRILL YOUR 4 MARKED SPOTS USING A
3
16
" DRILL BIT.
IF NOT GOING DIRECTLY INTO STUD, USE ANCHOR (ITEM 12). DRILL A
5
16
" HOLE AND HAMMER
ANCHOR INTO PLACE.
4. REPLACE YOUR UNIT TO IT'S ORIGINAL DESIRED LOCATION AND SCREW IN PLACE USING THE ALLEN
WRENCH (PART 10) AND SCREWS (PART 11) PROVIDED. DO NOT OVER TORQUE!
IMPORTANT: TO INSURE PROPER AND SAFE INSTALLATION OF YOUR SHELF; YOU MUST:
USE PART 9
& TIGHTEN
NEW CONNECTIONS
WARNING!
FAILURE TO PROPERLY MOUNT
SHELF AS INSTRUCTED MAY
RESULT IN SERIOUS INJURY!
11
10
2
3