Installation & Assembly

All Light fixtures are manufactured to be installed to a standard round junction box. The
instructions are written to start with a pre-existing junction box that is controlled by a switch. All
light fixtures are dimmer switch compatible. For the best results be sure that the light bulbs used
are also dimmer switch compatible.
1. Remove all items from their packaging.
• Light Fixture (actual light fixture will vary – but all fixtures that have a center finial follow
these instructions)
• Mounting hardware – both items are attached to the back of the fixture
- Crossbar
- Wire nuts
2. Remove the finial from the center of the fixture and remove the mounting hardware from the
crossbar
3. If a pendant, adjust the length of the individual pendants to the desired length
4. Attach the crossbar to the junction box with the included screws
5. With assistance, hold the fixture up to the junction box. Connect electrical wires from fixture to
existing power source. Connect the ground wire to the GND on the crossbar
6. Insert the finial into the fixture, align to center hole on cross bar and hand tighten.
7. Align the fixture in the direction desired
8. If you purchased the version with cages, remove the screws from the cage and fit around Black
Porcelain Sockets. Tighten the cages using screws.
9. Reconnect the power to the circuit (breaker or fuse)
10. Install your light bulbs and enjoy!