Assembly & Installation Instructions

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Installation Steps
1. Carefully unpack your new fixture and lay out all the
parts on a clear surface.
2. Choose the suitable number of stems and install the
Stem-1, Stem-2 into the Tube and Swivel.
3. Thread the Mounting screws into the matching
holes of the Mounting bar, and tighten with the Hex
nut. Thread the Ground screw into the hole of the
Mounting bar. Secure the Mounting bar to the outlet
box with the Outlet box screws.
4. Make Wire connections with Wire Connector:
---The smooth wire (w/ marking) from fixture to
Black Wire from power source.
---The ribbed wire (w/o marking) from Fixture to
White Wire from power source.
---Attach the Ground Wire and house ground
wire to the Mounting bar with the green Ground
screw.
Carefully tuck wires back into the Outlet Box.
5. Place the fixture Canopy over the two Mounting
screws so they protrude through the holes in the
Canopy. Thread the Ball nut onto the Mounting
screws and continue turning until the fixture is snug
against the ceiling.
6. Put the Metal shade onto the cup and tighten it
using the screw.
7. Install the light bulb (Not Supplied) in accordance with the fixture’s specifications.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
8. Place the Metal frame into the Metal ring, then raise the metal ring to the Metal shade and secure with screw.
9. Turn on the power at fuse or Circuit Box. Turn power off before starting.
WARNING:
ASSEMBLY AND INSTALLATION INSTRUCTIONS