Assembling & Installation Instructions

ManualsBrandsWilliston Forge ManualsCeiling LightsNedra 5 - Light Shaded Drum Chandelier

ASSEMBLING & INSTALLATION INSTRUCTIONS

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

ASSEMBLING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and all

hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear area.

Take care not to lose any small parts necessary for installation.

3. Raise the end of pipe thread (C) into coupling, lock it with the hex nut until

tight. Raise the other end of pipe thread(C) into single bar (D), place lock

washer (B) over the end of thread protruding through single bar and lock it

securely with the hex nut (A).

4. Slide the electrical wires through the pipe thread (K)/ tube(L)/(J)/(I)/(G)/

ring(H)/canopy(F) and assembled single bar(D).

5. Raise the pipe thread(K) into the top coupling of lamp body(M), lock it

securely with the hex nut. Raise the tube (L) insert to the pipe thread, lock

it securely with the tube(J), raise the tube(I)/(G) and assembled single

bar(D) to the screw pipe nipple in order, then by turning it clockwise until

tight.

6. While holding the assembled single bar(D) of fixture body to the ceiling

junction box with junction box screws(E) as shown, tighten screws

securely with screwdriver. The side of the single bar marked "GND" must

face out. The junction box is not included.

7. Connect the electrical wires as Shown in Fig.2, making sure that all wire

nuts are secured. You may have to wrap the connections with electrical

tape. If your outlet has a ground wire (green or bare copper), connect the

fixture ground wire to it. Otherwise connect fixture’s ground wire directly to

the single bar with the green screw provided. After wires are connected,

tuck them carefully inside the Junction Box.

8. Slide the canopy(F) onto the Junction box, lock it securely with the ring(H)

until tight.

9. Install the light bulbs(Not included) in accordance with the fixture

specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!

Your installation is now complete. Return power to the

junction box and test the fixture.

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black(Hot)

FIXTURE

WIRES

White or

Ribbed

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

White

(Neutral)

HOUSE

WIRES

Green or Bare

Copper(Ground)

FIG.2 FIG.1

Thank you for purchasing our product.

Need assistance with parts or assembly? Please call customer service.