Assembly Instructions

1. REMOVE ALL PARTS FROM PACKAGE, BE CAREFUL NOT TO DAMAGE ANY COMPONENTS.
2. PUT METAL PARTS [N] TO SOCKET PART [O]SCREW TUBE [M] TO METAL PART [N], THEN SCREW [L]
TO [M], SCREW [K] TO [L], SCREW [J] TO [K],SCREW [I] TO [J],REMOVE PARTS [M],[L],[K],[J],[I] TO
ADJUST THE HEIGHT OF THE FIXTURE AS NEEDED. THEN TIGHTEN THE CANOPY[F] TO [I].
3. REMOVE WALL BRACKET FROM THE LAMP FIXTURE AND ATTACH THE MOUNTING CROSS BAR [C]
INTO THE CEILING BRACKET AND FASTEN WITH THE MOUNTING SCREWS [E] (2PCS).
4. CONNECT THE BLACK CORD OF LAMP WITH THE ANODE WIRE ON WALL BRACKET BY
CONNECTOR[A], CONNECT WHITE CORD OF LAMP WITH CATHODE WIRE ON WALL BRACKET
BY CONNECTOR [B]. CONNECT THE GROUND WIRE TO THE WALL GROUND WIRE BY CONNECTOR.
5. TIGHTEN THE CANOPY [ F] ON THE MOUNTING CROSS BAR [C] THROUGH SCREW[D] BY NUT [H].
ASSEMBLY INSTRUCTIONS
ASSEMBLY STEPS:
CAUTION
: PULL ANY EXCESS WIRE THROUGH BOTTOM OF THE LAMP.
TO CLEAN, USE A SOFT CLOTH ONLY.
NOTE: TURN THE POWER OFF BEFORE REPLACING THE BULB. MAKE SURE THE BULB HAS
SUFFICIENT TIME TO COOL DOWN. DO NOT SUBJECT THE LAMP TO ANY
SHOCK WHILE LIT AS
SHATTERING OF LAMP MAY RESULT.