Assembly Instructions

Assembly Instructions:
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down the
xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture.
For Customer Service, please
contact the place of purchase.
PREPARING FOR INSTALLATION
Remove all of the contents from the carton. See the important notes
above. Remove the old xture from the ceiling, including the old
mounting strap.
1. Take the mounting strap assembly from the parts bag. Mounting strap
(B) contains several threaded holes. Two of mounting screws (A) should
be attached to mounting strap (B). You may need to tighten nuts (C)
that hold these screws in place. If the screws are not attached, please
hold canopy (F) up to mounting strap (B). Line up the holes in canopy
(F) with the holes in mounting strap (B) and insert mounting screws (A)
into mounting strap (B) so that mounting screws (A) protrude through the
holes in canopy (F)). Mounting screws (A) are long, please test canopy (F)
against the mounting strap to see how far you should insert the screws.
Tighten nuts (C) onto mounting screws (A) to hold the screws in place.
2. Place mounting strap (B) over the junction box so that mounting
screws (A) are vertical, and in alignment with the hole locations on
canopy (F). Secure mounting strap (B) to the junction box with mounting
screws (D) and a screwdriver. Tighten the screws securely.
CONNECTING THE WIRES
3.Haveanassistantsupportthexture’sweight
while completing the wiring. Refer to the wiring
diagrambelowandattachthexture’swires
to the power supply wires from the junction
box. Connect Hot to Hot, Neutral to Neutral,
and Ground to Ground. Twist the ends of the
wire pairs together, and then twist on a wire
connector. Make sure all twists are in the same
direction. If there is no house ground wire
coming from the junction box, locate ground
screw (E) on the mounting bracket/mounting
strapandwrapthexture’sgroundwirearound
the ground screw. Use a screwdriver to tighten
the top of ground screw (E) onto the wires and
into the mounting bracket/mounting strap. Tuck
the wires into the junction box.
FINISHING THE INSTALLATION
4. Raise canopy (F) to the ceiling. Position mounting screws (A) so that they protrude through the openings of canopy (F). Secure canopy
(F) in place with decorative nuts (H).
5.Installlightbulbs(notincluded)inaccordancewiththexture’sspecications.
Yourinstallationiscomplete.Turnonthepowerandtestthexture.
How to Identify the Fixture’s Wires
Hot Neutral Ground
Smooth
Ribbed
Bare Metal,
Green, or
Green Inner
Thread
Black
White
Black Inner
Thread
White Inner
Thread
House Wires
Fixture Wires
Hot
NOTE: Please use the
attached hexagonal
spanner tool to tighten
the center rod until the
cables are tight. Then
double check that the
shade is straight.
B
D
A
E
C
F
H