Installation & Assembly

Page:  ‐2‐/4
Beforedoingassemblyandinstallationpleasepreparetheneededtoolsasbelowpicture










PARTSTYPE&QTYINCLUDING: 
(B)Single bar (1)
(C) Green ground screw (1)
(E) Nipple (1)
(F) Hex nut (2)
(G)Canopy (1)
(H) Threaded ring (1)
( I ) Screw collar loop (1)
(J) Quick link (8)
(K) Chain (1)
(L) Loop (1)
(M) Frame (1)
ACCESSORIES&QTYENCLOSED: 
(A)Plastic wire connector (3)
(D) Mounting screw (2)
ASSEMBLY&INSTALLATIONINSTRUCTIONS:
1. Carefullyremovethefixturefromthecartonandcheckthatallpartsand
 accessoriesareincludedasshownintheaboveillustration
2.   Makeassembly

If the group of parts are not already assembled:


 StepA1:Threadthenipple(E)intothescrewcollarloop(I)
  StepA2:Threadtheanotherendofnipple(E)intosinglebar(B)thenplacehexnut(F)overthetopofnipple.
  StepA3:Tightenthehexnut(F)untiltight.Atthispoint,thesideofsinglebarmarked"GND"mustfacetothescrew
collarloop(I).
3.Makepre‐installation
  Weareheretohelp!