Installation & Assembly

 Page:  ‐3‐/3


StepA1:Unscrewtheknobnut(F)frombackplate(E)thengentlyremovemountingplate(B)
StepA2: Carefullypullwiresfromoutletboxthroughmounting plate (B)
By measuring, determine the correct distance of drilling hole for anchor knocked into wall, then drill holes and gently
knock the anchors into wall until them are level to the wall
Attach the mounting plate (B) to
outletbox with mounting screws (F) and tapping screws(C)
StepA3:Makewireconnections
   Connectwiresasbelowwiresconnectingshown.TAKENOTEOFYOURWIRECOLOROFFIXTURE,NEVERCONNECT 
WIRETOGROUNDWIRE
ConnectgroundwireaccordingtobelowchartConnectwiresaccordingtobelowchart 









Twistplasticwireconnectoruntilwiresaretightlyjoinedtogether,carefullytuckallwiresintotheoutletbox
StepA4:Putthebackplate(E)tothewall,carefullypassthethreadednipplethroughholesinthebackplateandsecurethem
withknobnuts(F)
Installbulb(Notincluded.Pleasedonotexceedthemaximumcapacityrecommendedonthesocket.)
4.
Checkeverythinginstalledproperly,thenyoucouldturnonthelight. 

CLEANING 
To clean, wipe fixture with a soft cloth. Do not use abrasive materials such as scouring pads or powders, steel
wool or abrasive paper.
ORDERINGPARTS 
Keep this sheet for future reference, and in case you need to order replacement parts. All parts for this fixture
can be ordered from place of purchase. Be sure to use exact wording from illustration when ordering parts.