Installation & Assembly

 Page:  ‐2‐/4
TOOLSREQUIRED(NOTINCLUDED):
Beforedoingassemblyandinstallationpleasepreparetheneededtoolsasbelowpicture










PARTSTYPE&QTYINCLUDING: 
(B) Round mounting plate (1)
(C) Green ground screw (1)
(E) Canopy (1)
(F) Loop (2)
(G)
Quick link (2)
(H) Knob ball (2)
( I ) Tube (6)
(J) Glass (8)
(K) Stud (1)
(L) Fixture (1)



ACCESSORIES&QTYENCLOSED: 
(A)Plastic wire connector (3)
(D) Mounting screw (2)
ASSEMBLY&INSTALLATIONINSTRUCTIONS:
1. Carefullyremovethefixturefromthecartonandcheckthatallpartsand
 accessoriesareincludedasshownintheaboveillustration
2. Turnoffpower
3. Unscrewthestudsfromthesocketcapoffixture(L).
Theninstallthebulb  (notincluded)(Pleasedonotexceed 
themaximumcapacityrecommendedonthesocket.)
Gently and carefully position glass onto the socket cap,
adjust the glass to make the holes to be aligned with
glass and socket cap,then secure with the studs (K)