User Guide
Table Of Contents
- System Overview
- Receiver Safety Information
- Recycling Instructions
- Setting Up the PPA VP 37
- Locking Instructions
- Receiver Model PPA R37 Instructions
- Receiver Model PPA R37-8 (optional) Instructions
- Receiver Model PPA R38 (optional) Instructions
- Belt Clip Installation (all Receiver models)
- Using A Receiver With A Hearing Aid
- Receiver Management Suggestions
- Receiver Battery Information
- Troubleshooting Guide
- Personal PA Value Pack System Specifications
- Lifetime Limited Warranty
- Repair Services
PPA T27
9
Receiver Model PPA R37-8 (optional) Instructions
The PPA R37-8 is an eight channel receiver, operating on 72-76 MHz
bandwidth.
Figure 5: PPA R37-8 Controls
ON/OFF, VOLUME
CONTROL DIAL
HEADPHONE
JACK
"ON"/LOW
BATTERY
INDICATOR
CHANNEL
SELECTOR
KNOB
OFF
Battery Installation
Install two (2) AA alkaline or Nickel–metal hydride (NiMH) rechargeable
batteries. Open the battery compartment by lifting the tab on the back of
the receiver with a finger. To remove batteries, pull up on the fabric strip.
If Alkaline (or non-rechargeable) batteries are being installed, slide the
battery selection switch above the battery compartment to the Alkaline
position. If installing NiMH (or rechargeable) batteries, slide the battery
selection switch to the NiMH position.
Press the batteries into place over the fabric strip. Be sure to observe
proper polarity (+/-). Close the battery door.
Important: Damage due to improper battery installation may void the
warranty on the product.
The red LED on indicator on top of the unit will flash to indicate low battery.
When the sound becomes weak or distorted, replace or recharge the
batteries.
Connecting Earphones
Plug the earphone into the headphone jack on the top of the unit.
Williams AV can only assure optimum performance when Williams AV
earphones and headphones are used.