User Guide

PPA T27
8
Operating the Receiver
1. Insert two (2) AA batteries, ensuring correct polarity. If rechargeable NiMH
batteries are to be used, make sure the Alkaline/NiMH switch inside the
battery compartment is set to NiMH before charging. See Figure 4.
2. Insert headphone, earphone or neckloop into the stereo output jack.
3. Turn receiver on by turning up the volume control. The green power LED will
blink and then stay on continuously. See Table 1.
4. Set receiver frequency to match transmitter frequency. Press the Channel
Seek button inside the battery compartment once to seek an active
transmitter. See Figure 4. If more than one transmitter is being used, you will
need to push the seek button additional times until you locate the signal you
want to hear. The receiver will retain the channel setting when the unit is
turned o.
Figure 4: Battery and Channel Selections
AA
AA
–
+
+
–
Channel
Seek
ALKALINE/
NiMH SWITCH
A130
CHANNEL
SEEK BUTTON
5. To lock or unlock a selected channel, turn the power o. While holding the
seek button, turn the power back on. When locked, the receiver will remain
on the current channel, regardless of channel seek button presses.
Table 1: LED Flash Codes
Light Code Indicates Description
1 blink Channel locked Seek press remains on current channel
2 blinks Channel unlocked Seek press tunes to next channel present
3 blinks Channel unlocked; no other
channels present
Seek press attempts to find another
channel
On-O-On-O...
(continuous)
Batteries are low Batteries need to be replaced or
recharged
Fade-on, Fade-o...
(continuous)
No transmitter present on
current channel
Sleep/Power Save mode (extends battery
life)