User Guide
Table Of Contents
- System Overview
- Receiver Safety Information
- Recycling Instructions
- Setting Up the PPA VP 37
- Locking Instructions
- Receiver Model PPA R37 Instructions
- Receiver Model PPA R37-8 (optional) Instructions
- Receiver Model PPA R38 (optional) Instructions
- Belt Clip Installation (all Receiver models)
- Using A Receiver With A Hearing Aid
- Receiver Management Suggestions
- Receiver Battery Information
- Troubleshooting Guide
- Personal PA Value Pack System Specifications
- Lifetime Limited Warranty
- Repair Services
PPA T27
7
7. Listen with an FM Receiver.
IMPORTANT: The FM receiver being used with the T27 transmitter will
need to be on the same frequency as the transmitter.
Install the receiver batteries, plug in the earphone, turn on the receiver and
walk around the listening area. The signal should be clear and quite loud
when the volume is turned up.
Locking Instructions
To LOCK the desired frequency, press and hold both down and up
frequency selector buttons for 3 seconds until the word Loc appears on the
display. The frequency is now locked. Should the user press the frequency
selector button while in Lock mode, the word Loc will be displayed for 2
seconds. The transmitting channel will remain unchanged.
To UNLOCK the desired frequency, press and hold both down and up
frequency selector buttons for 3 seconds until the transmitter displays
Un then Loc on the display. The frequency is now unlocked and can be
changed as needed.
Receiver Model PPA R37 Instructions
PPA R37 is a 17-channel receiver operating on the 72-76 MHz bandwidth.
Figure 3: PPA R37 Controls
ON/OFF, VOLUME
CONTROL SWITCH
EARPHONE
JACK
"ON" / LOW BATTERY/
FLASH CODE INDICATOR
OFF