User Guide
Table Of Contents
- System Overview
- Receiver Safety Information
- Recycling Instructions
- Setting Up the PPA VP 37
- Locking Instructions
- Receiver Model PPA R37 Instructions
- Receiver Model PPA R37-8 (optional) Instructions
- Receiver Model PPA R38 (optional) Instructions
- Belt Clip Installation (all Receiver models)
- Using A Receiver With A Hearing Aid
- Receiver Management Suggestions
- Receiver Battery Information
- Troubleshooting Guide
- Personal PA Value Pack System Specifications
- Lifetime Limited Warranty
- Repair Services
PPA T27
13
5. To access additional settings, push and hold the menu button. The receiver
will display Loading Advanced Setup. After viewing or changing a setting,
push the menu button again to access the next setting. If no buttons are
pushed during the screen time-out period (adjustable in menu), the display
returns to the main screen, and then shuts o to conserve battery power.
The receiver remains on.
Figure 8: Top of Receiver
3.5mm
STEREO/MONO
HEADPHONE
JACK
POWER BUTTON/
LOW BATTERY
INDICATOR
6. Plug in the earphones/headphones into the headphone jack (Figure 8). The
earphone/headphone cord functions as the antenna.
7. Adjust the volume by pushing the left or right arrow buttons (Figure 7).
8. To lock or unlock all of the settings (except volume), push and hold the left
and right arrow buttons. Three dashes will appear and then disappear. Keep
holding the buttons until the last dash disappears, and the screen prompts
to push the menu button. After pushing the menu button the receiver will
display Settings Locked (or Unlocked).
Belt Clip Installation (all Receiver models)
To Install:
Position the belt clip on the rear of the PPA R37, PPA R37-8, or PPA R38
receiver as shown in Figure 9. Turn the belt clip 180º left or right as shown
in Figure 9. The belt clip is now installed and ready for use.
To Remove:
Turn the belt clip 180º so the edge points toward the top of the unit as
shown in Figure 9. Gently pull the belt clip away from the unit to remove.