Installation guide

USING THE OPTIONAL WIR TX9 SLAVE EMITTER FOR ADDITIONAL COVERAGE
For larger facilities, additional emitter panels can be used to increase the overall coverage area. In these
cases, we recommend using the WIR TX9 slave emitter in tandem with the WIR TX90. The WIR TX90 can
drive multiple WIR TX9 emitters at one time. Each TX9 emitter will require its own power supply.
To add a second WIR TX9 emitter panel to the WIR TX90 transmitter, repeat the process above
(the WIR TX90 transmitter has two baseband output jacks).
Note: The WIR TX9 emitter panels can be “chained” together if needed for unlimited coverage area.
Each WIR TX9 emitter will require its own power supply. See Figure 12 below.
To TX9 Emitter
Baseband
Input
Baseband
Output
WIR TX9 Emitter (Rear) WIR TX90 Transmitter (Rear)
FI
GURE
11: CO
NNECTING A
WIR TX9 EM
ITTER TO A
WIR TX90 TR
ANSMITTER
To TX9 EmitterTo Second TX9 Emitter To Additional EmitersTo additional Emitters
WIR TX9 Emitter #1 (Rear) WIR TX90 Transmitter (Rear)WIR TX9 Emitter #2 (Rear)
Baseband
Input
Baseband
Output
Baseband
Input
Baseband
Output
Baseband
Output
Baseband
Output
FIGURE 12: CHAINING MULTIPLE WIR TX9 EMITTERS TOGETHER
9