User manual

DigiWave 300 Series Digital Transceiver and Receiver
14
Address Conrmation
Press MENU three times for M1 and M2, or twice for GST units. The address for the DLT will be displayed for two seconds.
NOTE: Every DLT MUST have its own address and all must be assigned to the same group.
Quick Group Change
“Groups” apply to 2-way Mode only.
1. With the DLT powered ON, push and hold the Group button until the GROUP indicator on the screen starts blinking and the
light above the Group button comes on (Figure 5).
2. Change groups by pushing the Up button or the Down button . If no buttons are pushed, the
Quick Group Change feature will time out after 5 seconds.
3. Push the Group button once to exit the Quick Group Change function, or wait for 5 seconds.
Push-to-Talk (Ptt) and Push-and-Latch (PNL)
This feature allows the user to choose between Push and Latch (PnL) or Push to Talk (Ptt). The default is PnL.
In PnL mode, when the TALK button is pressed and released, it stays in talk mode until the TALK button is
pressed and released again.
In Ptt mode, the TALK button must be held down while speaking, and when released, it shuts o.
The DLT must be set up as a Guest unit, in 2-way mode, prior to performing these steps.
1. With the DLT powered ON, press and hold the Up button and the Down button simultaneously
for 2 seconds to enter programming mode.
2. Push the Power/Menu button until the TALK indicator is ashing and either “PnL” is or “Ptt” is displayed.
(Figure 6).
3. Use either of the -/+ buttons to switch between “PnL” and “Ptt”
4. Press and hold the Up button and the Down button simultaneously for 2 seconds to exit
programming mode.
Side Tone Adjustment
This gives the user the ability to change the volume of their own voice heard in the headset (side tone).
1. With the DLT powered ON, press and hold the Up button and the Down button simultaneously for 2 seconds to enter
programming mode.
2. Push the Power/Menu button until “St:” is displayed. See Figure 7.
3. Use either of the -/+ buttons to choose between Stt:0 (O), St:1 (-6dB) (default), or St:2
(-12dB).
4. Press and hold the Up button and the Down button simultaneously for 2 seconds to exit
programming mode.
Microphone Level or Line Level Adjustment
To enter Microphone Level Adjustment, hold the button for two seconds. To enter Line Level
Adjustment, hold the button for two seconds. Then use or buttons to adjust the level.
Time Display
The time function is available in 2-way or 2-way Intercom Modes only. The Master Unit (M1) can determine whether the time of day is
displayed on all units in the group. When this feature is enabled, all units sync their time from the Master. To enable time display: Start
with the M1 unit powered o. While holding the TALK button , power the M1 unit ON. Time will now be displayed on all units in
the group. Repeat this procedure to disable time display on all units in the group.
Talk “O” Double-Beep Indication Limit
The user hears an audible “double-beep” sound when the TALK button is turned o. This is heard in the headset of the user only;
it is not transmitted. On the DLT 300, as the headset volume is increased, the beep volume will increase until the headset volume
reaches 37, then the beep volume will stop increasing. (Note: On the DLT 100 model, the beep volume continued to get louder as the
headphone volume was increased, with no limit.)
FIGURE 5
FIGURE 6
FIGURE 7
Ptt & PnL fig. 6
Ptt & PnL fig. 6
Side Tone fig. 7