User manual

DigiWave 300 Series Digital Transceiver and Receiver
13
Programming the Digi-Wave™ System: DLT Optional Settings
Secure Key Code:
When a group has been set up and the same Secure Code has been entered into all the DLTs, the DLTs without this Secure
Code entered cannot listen in on the group. This may be desirable in private or high security-level functions.
The same four digit code must be programmed into all of the DLTs, Master 1, Master 2 and Guests. If a dierent secure code has
been entered, participants cannot re-enter the group without re-entering the correct secure code. The only time the Secure Code
is displayed is when it is being entered. To block users from entering the set-up mode, refer to the SET-UP LOCK (SLOC) feature
(below).
1. Choose a 4 digit numerical code; i.e. 1357. You must use the same code on each DLT in the group.
2. Start with the Master 1 when programming.
3. With the DLT turned on, hold the and buttons simultaneously for two seconds to
enter the set-up menu.
4. Use the menu button to scroll through the menu pages until you get to the screen displayed
in gure 1.
5. The rst dash will be blinking (gure 1); using the button, enter rst digit of the code
(0 – 9).
6. Press the menu button again to move to the second dash which will now be blinking.
7. Enter the next digit and continue until all four digits have been entered.
8. One more press of the menu button and you will see the word CodE displayed (gure 2).
9. With the Secure Key Code entered, exit the set-up menu by holding the and buttons simultaneously for two
seconds.
10. Follow the same process with the Master 2 and Guest units.
NOTE: There will be fewer pages to scroll through on the Master 2 and Guest units to get to the code set-up screen.
SET-Up Lock (SLOC)
Set-up Lock enables the Administrator to prevent unauthorized changes to the system set-up.
NOTE: Each DLT has to be locked and unlocked individually.
1. Press twice, then twice (
^
-
^
-v-v). This has to be done within 5 seconds. ‘SLOC’ will
appear momentarily on the screen (gure 3). SLOC is now enabled.
2. When SLOC is enabled, if a user tries to change any setting by entering the set-up mode, ‘SLOC’
will appear momentarily on the screen. See gure 3.
3. To unlock this feature, the same (
^
-
^
-v-v) sequence must be entered. There will be no prompt
showing that SLOC was disabled. Accessing the set-up mode is the indication that SLOC is disabled.
NOTE: Each DLT has to be locked and unlocked individually.
Attendee Checking
When the M1 presses the MENU button once, the number of Guest devices connected to the system will be displayed for two
seconds. Addresses 0 - 99 must be used for attendee checking feature. Addresses over 99 will not be registered. ie: C 12 = 12
DLTs synched with M1.
Tone Control
1. With the DLT powered ON, press and hold the – and + buttons simultaneously for 2 seconds.
2. The LCD will display the last tone setting t: (1 - 9). See Figure 4.
3. Using the -/+ buttons , adjust the tone up or down:
1 = Most bass response 5 = Flat (Default) 9 = Most treble response
4. Press and hold the – and + buttons simultaneously for two seconds to save the tone setting.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4