User manual

DigiWave 300 Series Digital Transceiver and Receiver

Programming the Digi-Wave™ System for 1-way Modes

There are 4 basic steps to programming a Digi-wave system:

1. Set Mode: 2-way or 1-way

2. Set Priority: Master 1, Master 2, and Guest

3. Set Channel

4. Set Group Number

Most of the programming is done on the DLT(s); the receivers just need to be assigned the correct group number. The Master 1

should be programmed rst - all other units synchronize with the Master 1.

Step 1. Set Mode: 1-way

a. With the DLT turned on, press and hold the and buttons until the icons on the display begin ashing.

b. Use either of the the buttons to scroll through the dierent icon combinations (modes).

c. When you reach the 1-way mode you are looking for (below), go to step 2.

1-way - Main Speaker:

1-way - Interpreter:

1-way - Repeater Mode:

1-way - Receive or Listen Only:

Step 2. Set Priority: Master or Guest

a. Push the button to advance to the priority setting.

b. Use either of the the buttons to scroll through the dierent priorities. Speaker priority is assigned as follows:

1st priority — Master: (Must have one master per group)

2nd priority — Guest: (All other units in the group)

c. When you reach the priority you want, go to the next step.

Step 3. Set Channel

a. Push the button to advance to the address setting. “CH” will ash and the current address will be displayed.

b. Use either of the the buttons to change the address.

Step 4. Set Group Number

a. Push the button to advance to the group setting. “GROUP” will ash and the current group will be displayed.

b. Use either of the the buttons to change the group.

c. All units operating together should have the same group number.