User manual

DWD 102 Digi-Wave™ Dual-Bay Docking Station
5
DLT microphone mixing with dock sources
The dock’s inputs - two mono RCA jacks (-10dBV) and one XLR jack (+4dBu) - are mixed together in the dock, then sent to the DLT
100 2.0. The DLT 100 2.0 then mixes the dock audio with it’s microphone before transmitting.
Depending upon what sources are being mixed, there may be a level mismatch between the dock and the DLT’s microphone level.
The DLT 100 2.0 includes line-level adjustment for proper mixing.
To adjust the DLT 100 2.0 line-level gain, hold the “^” button for 3 seconds. The default level is “L:5”, or 0dB of gain adjustment. See
Figure 4 below for level settings and corresponding gain/attenuation.
Figure 4: DLT Setting/Digi-Wave™ Dock Functions
Level Setting on DLT
0 1 2 3 4 5 6 7
Line-level Gain/At-
tenuation (dB)
Muted -12dB -9dB -6dB -3dB 0dB +3dB +6dB
Note: The “microphone volume” adjustment can also be used, but may require other DLTs microphone levels to be adjusted too,
which makes it a more cumbersome method, and therefore line-level adjustment is recommended.
Installing the Support Pads
Two sets of supporting pads have been supplied with the dock to support the back of the unit(s) when sitting in the dock; thick (1/8”)
and thin (1/16”). Use the table below to choose which pad thickness to use (Figure 4). See the diagram below showing where to affix
the pads (Figure 5).
Figure 5: Support Pad Required
DLT 100 DLT 100 with skin DLR 60 DLR 60 with skin
Thick pad (1/8”) Thin pad (1/16”) Thin pad (1/16”) No pad
Figure 6: Support Pad Installation
A488