User manual

DWD 102 Digi-Wave™ Dual-Bay Docking Station

Setup Instructions:

1. Connect the external devices to the XLR or RCA jacks on the back of the Digi-Wave™ Dock (Figure 1). Both RCA and the single

XLR input jacks are all mixed internally - but for proper mixing to occur at the output without any adjustments, the following

combinations can be used: One single RCA jack by itself, both RCA jacks, the XLR jack by itself, or both RCA jacks and the XLR

jack. If one RCA jack is to be mixed with the XLR jack, the gain of the RCA source will need to be adjusted at the source.

2. Select DLT mode. We recommend using “Chairman Master” mode for two reasons: (1) The Chairman Master has #1 Talk Priority

so the Talk button on this unit can never be bumped off by another user, and (2) The Chairman Master will be powered by the

dock, and all other units synchronize to the Chairman Master, making it a more reliable Master than one powered from the

internal battery.

3. Insert any combination of DLT 100 2.0 transceiver(s) or DLR 60 2.0 receiver(s) into the bays (Figure 2). The unit(s) must be facing

forward for proper mating to the 30-pin connector.

4. Using the appropriate line cord (US, EURO, UK or AUS) into the TFP 048, plug the TFP 048 power supply into the AC wall outlet.

Plug the power connector into the rear of the DWD 102 unit (gure 1). The green LED power indicator should light up (Figure 2).

5. Select either Auto or Manual for each docked device, using the switch(es) on the back. See Figure 3 for an explanation of the

difference between the two modes.

You may charge any combination of DLT 100 2.0, DLT 100, DLR 60 2.0, or DLR 60s. (In DLR 60 2.0 and DLR 60 units, NiMH batteries

must be used and the battery switch must be in the NiMH position.) Digi-Wave™ Dock audio inputs/outputs are only available on the

DLT 100 2.0, DLR 60 2.0, and DLR 60. DLT 100s can be docked but will charge only (no audio). See Digi-Wave™ Dock Functions

chart (Figure 3).

Note: It is safe to leave the DLT and DLR units in the charger, even after the batteries are fully charged. The charger will

switch to ‘maintain’ mode to maintain full battery potential.

Figure 3: Digi-Wave™ Dock Functions

DLT 100 2.0 DLR 60 2.0 / DLR 60

Charges Unit with

Dock Power ON

Yes (internal battery)

Yes - with NiMH AAA batteries in DLR only; if no batteries

present dock will power DLR (if battery switch is in NiMH

position).

Charging Status Shown on DLT if unit is OFF Shown on DLR (NiMH only)

Internal Mic Muted when docked n/a

Internal Speaker Muted when docked Muted when docked

Audio Inputs/Outputs Input and Output enabled Output enabled

Auto Mode

TALK function

When unit is Chairman Master in 2-way mode, or Presenter

in 1-way mode (CH 0), TALK button is locked ON. No

effect in other modes

n/a

Power-Up Powers-up DLT when power applied to dock Powers up DLR when power applied to dock

Manual Mode

TALK function TALK button must be pushed manually n/a

Power-Up Acts as a charger only Acts as a charger only